Imported and Distributed by Link Technology

Phone: + 64 (0)4-566-9699
Contact Owner: Harry Memelink
Mobile: + 64 (0)21-586-077
Email: Linktech@ihug.co.nz

C/O Unit 1
408 Hutt Road,
Alicetown, Lower Hutt 5010
Wellington
Email Us

www.proxxontools.co.nz
103.232.226.155

Link Technology also market and sell the following products:






24004

Precision Lathe PD 230/E

NO 24004

For spindle speeds from 100 to 3,000 rpm. Useable on materials such as plastic, steel, brass, aluminium. Complete with automatic feed, thread cutting facility, gear chuck, live centre and top slide for taper turning. Used to part, machine stock and cut tapers. The numerous optional accessories enable one to drill, mill and slot.

The quality is clear to the touch and sight. The PD 230/E is made for people which are associated with quality. It is not necessary to have the proficiency of a trained mechanician to handle the PD 230/E.

Technical Data:

  • Centre distance 230 mm, swing 56 mm.
  • Height over cross slide 28 mm.
  • Cross slide travel 60 mm and top slide 45 mm.
  • Tool holder for cutters 8 x 8 mm.
  • Spindle bore 10.5 (spindle run out 0.01 mm without chuck), with MT 1 (short).
  • Spindle speeds of 300, 900 and 3,000 rpm are provided.
  • The automatic feed may be set either 0.05 or 0.1 mm/revolution.
  • Tailstock barrel feed of 30 mm and MT 1 (short).
  • The capacitor motor operates at 220 - 240 Volt, 50 Hz mains with 140 W input / 60 W output as well as bi-directional operation.
  • Workpieces are fitted to the 3 jaw chuck (2 - 35 mm) and with outside jaws (24 - 68 mm).
  • Feed knobs have a feed of 1 mm/revolution.
  • Each revolution is calibrated in 40 divisions, with one division = 0.025 mm.
  • Weight approx. 10 kg.
  • Overall dimensions approx. 530 x 250 x 150 mm.
  • The thread cutting facility yields the most important pitches: 0.5 - 0.625 - 0.7 - 0.75 - 0.8 - 1.0 - 1.25 - 1.5 mm (metric).
  • Fitted with precision ball bearings.

Included:
The top slide, used for taper turning, and the tool holder are included as standard!
MT 1 live centre included as standard.

Centre Turning Attachment
Used for highest accuracy with high rotational precision. One faceplate, 2 fixed MT 1 (short) centres, and 1 drive dog are included. Supplied in a wooden box with sliding lid.

Collet Set for accurate use on round components
One each 2.0 - 2.5 - 3.0 - 4.0 - 5.0 - 6.0 - 8.0 and 10 mm are included. Concentric accuracy better than 0.2 mm, much better than a chuck. The collets are mounted in the place of the headstock chuck. Supplied in a wooden box and lid.