Imported and Distributed by Link Technology

Phone: + 64 (0)4-566-9699
Contact Owner: Harry Memelink
Mobile: + 64 (0)21-586-077
Email: Linktech@ihug.co.nz

C/O Unit 1
408 Hutt Road,
Alicetown, Lower Hutt 5010
Wellington
Email Us

www.proxxontools.co.nz
103.232.226.155

Link Technology also market and sell the following products:






24104

Mill/Drill Head PF 230

NO 24104

Converts the Precision Lathe PD 230/E into a machining centre. Set includes column (35 x 400 mm), mounting bracket and bolts. The mounting position on the PD 230/E is already milled. The lathe's top slide is replaced with the table (supplied) of 110 x 70 mm, with 3 T-slots 12 x 6 x 6 mm. The lathe now functions as a compound table, with X-Y travel being longitudinally and cross-wise respectively. The mill/drill head is identical to the FF 250. Three collets of sizes 6, 8, and 10 mm are included.

Note: Lathe not Included

Fine Feed
Easily installed. The feed may now be used via either the height feed (vertical) or the fine feed in the tilted position. One revolution = 1.5 mm spindle travel, one division = 0.05 mm. The graduated scale may be reset to zero.

Technical Data:

  • 220 - 240 V.140 W. 50-60 Hz.
  • Spindle revolutions 280 - 550 - 870 - 1,200 - 1,500 und 2,200/min.