Imported and Distributed by Link Technology

Phone: + 64 (0)4-566-9699
Contact Owner: Harry Memelink
Mobile: + 64 (0)21-586-077
Email: Linktech@ihug.co.nz

C/O Unit 1
408 Hutt Road,
Alicetown, Lower Hutt 5010
Wellington
Email Us

www.proxxontools.co.nz
103.232.226.155

Link Technology also market and sell the following products:






27070

Table Saw FET

NO 27070

For fine mechanics, model building, mould construction, toy manufacture, architects, model carpenters and fitters.

For cutting wood, non-ferrous metals, plastics, Plexiglass, glass fibre reinforced sheets, foam and many other materials. Stable construction because load bearing parts and plane-milled table are made of die-cast aluminium.

The micro-adjustable, precise and stable longitudinal stop provides decisive advantages: corrections even smaller than 1/10 mm can be made after coarse adjustment using an adjusting screw. The height adjustable and 45° tiltable saw blade makes it possible to cut double mitres when used together with the angle stop.

Low-noise drive using DC special motor with Optibelt toothed belts. Ball-bearinged saw blade shaft. Tungsten tipped saw blade 80 x 1.6 x 10 mm (24 teeth). Additional work piece pusher and non-slotted ABS sawing gap cover for tight tolerances between saw blade and table.

Features:
  • Extendable table extension with integrated auxiliary stop.
  • Plane-milled table in diecast aluminium with 2 continuous T-nuts for the angle stop.
  • Sawblade protection runs up automatically when sawing.
  • Clamping screw for height adjustment and pivoting the hard metal-equipped sawblade.
  • Scale helps when adjusting the longitudinal stop!
  • Setting screw for fine adjustment of longitudinal stop by 1/10 mm.
  • Angle stop with stop rail in aluminium and adjustable limit stop for manufacturing parts of the same length and same angle.
Technical Data:

  • 220 - 240 V. 7,000 rpm.
  • Mitre infinitely adjustable up to 45°.
  • Table size 300 x 300 mm.
  • Cutting depth 1 - 22 mm.
  • Saw blades between 50 - 85 mm can be used (with 10 mm centre hole).
  • Weight approx. 6 kg.

Additional non-slotted sawing cap cover of ABS for tight tolerances between saw blade and table (is slotted from below by FET saw blade). For cutting very small parts.

Table and drive can be lifted up and supported like an engine bonnet. For cleaning the device and easy saw blade replacement.

Available as an option (article-no. NO 28 736): T-slot milling device. Consisting of milling protection and tungsten tipped saw blade 50 x 2 x 10 mm. For cutting slots in drawers, picture frames, etc. Milling depth max. 8 mm. Easy to assemble.