Imported and Distributed by Link Technology

Phone: + 64 (0)4-566-9699
Contact Owner: Harry Memelink
Mobile: + 64 (0)21-586-077
Email: Linktech@ihug.co.nz

C/O Unit 1
408 Hutt Road,
Alicetown, Lower Hutt 5010
Wellington
Email Us

www.proxxontools.co.nz
103.232.226.155

Link Technology also market and sell the following products:






28128

Bench Drill Machine TBM 220

NO 28128

Machined work top of high quality, ribbed die-cast aluminium (220 x 120 mm). Adjusted fence with scale. Solid, hard-chromed steel column, 280 mm high, 20 mm diameter. Super stable die-cast head with built-in, VDE approved 220 - 240 Volt, 85 W motor. Very quiet and of long life expectancy type.

Three step aluminium pulley with flat belt. 3 spindle speeds of 1,800, 4,700, and 8,500 rpm (triple torque at low speeds). Chrome feed lever with adjustable depth scale. The spindle is essentially free of play as a result of 3 high quality ball bearings. Recessed spindle for insertion of MICROMOT steel collets, but also threaded for drill chucks (3/8'' thread). Extremely high rotational accuracy, 30 mm feed. Practical, adjustable depth gauge. Throat depth (column to drill spindle) 140 mm. Six triple slit precision collets for shaft sizes 1.0 - 1.5 - 2.0 - 2.4 - 3.0 - 3.2 mm included.

Machine vice not included

NO 28122 - Optional Chuck for drill bits up to 6 mm

For drill shank sizes 0.5 - 6.0 mm. Max. speed 10,000 rpm. Industrial quality with extra high speed accuracy. With 3/8'' thread for MICROMOT bench drill TBM 220, including chuck key.

Steel Collets:
Six triple slit, hardened steel collets 1.0 - 1.5 - 2.0 - 2.4 - 3.0 and 3.2 mm and closure nut are included. With lock button for rapid cutter changing. MICROMOT steel collets are hardened and thus have a high, consistent flexibility. They also maintain prolonged accuracy, even after regular use (these collets should not be compared with unhardened four-slit collets of brass and aluminium). The triple slit collet is substantially more difficult to manufacture than the four-slit type, but offers a better load-bearing surface. This is especially important for cutters with small shank diameters.